lokakuu 07, 2024, 00:24:09 ap

Uutiset:

Iloista kasvatuskautta !!


SIP (Sub-Irrigated Planter)

Aloittaja chilley, toukokuu 01, 2012, 18:01:23 ip

« edellinen - seuraava »

chilley

toukokuu 01, 2012, 18:01:23 ip Viimeisin muokkaus: toukokuu 02, 2012, 16:19:58 ip käyttäjältä chilley
Internetin ihmeellistä maailmaa selatessa tuli vastaan tämmöinen viritelmä. Itse en ole moista kokeillut mutta saattaapi olla ihan toimiva ratkaisu? Ei tosin mikään kovin esteettisen näköinen.



Jääkiekon maailmanmestaruuskisojen kunniaksi:
"Olen pelannut Gordie Howea ja Alexander Ragulinia vastaan, ja tiedän mitä kaukalossa oleminen tarkoittaa : "If you can't stand the heat, stay out of the kitchen". - Juhani "Tami" Tamminen

Aku

Kyseessähän on ihan normaali altakasteluruukku ;)

PP

Kätevä ja etenkin halpa systeemi, mutta et viittis pienentää noita kuvia. Hiukka leveitä ovat, kun selain koko ruudussa ei riitä full hd-näytöllä. :)

chilley

Lainaus käyttäjältä: PP - toukokuu 01, 2012, 22:58:36 ip
Kätevä ja etenkin halpa systeemi, mutta et viittis pienentää noita kuvia. Hiukka leveitä ovat, kun selain koko ruudussa ei riitä full hd-näytöllä. :)


Saako tämän tehtyä suoraan foorumilta? Olen nimittäin linkannut nuo kuvat suoraan toiselta foorumilta. Voin toki pienentää kuvat ja uploadata ne uudestaan mikäli foorumilta ei moista toimintoa löydy.
Jääkiekon maailmanmestaruuskisojen kunniaksi:
"Olen pelannut Gordie Howea ja Alexander Ragulinia vastaan, ja tiedän mitä kaukalossa oleminen tarkoittaa : "If you can't stand the heat, stay out of the kitchen". - Juhani "Tami" Tamminen

lampuusi

Näitä on tullut askarreltua muutamana keväänä, ihan kätevä ja tosiaan halpa ratkaisu.

Näppäränä pienenä yksityiskohtana vielä leikkaa tuohon alemman osan yläreunaan sopivan kokoisen 'kielen' joka toimii täyttöaukkona. 'Kieli' pelkän reiän sijasta niin se toimii korkkina ja pienentää (sinällään olematonta) haihtumista.

PP

Lainaus käyttäjältä: chilley - toukokuu 02, 2012, 00:10:10 ap
Saako tämän tehtyä suoraan foorumilta? Olen nimittäin linkannut nuo kuvat suoraan toiselta foorumilta. Voin toki pienentää kuvat ja uploadata ne uudestaan mikäli foorumilta ei moista toimintoa löydy.


Juu, laita img-kohtaan hakasulkujen sisään width=xxx, jossa xxx on kuvan leveys pikseleinä.

ChIlIDoG

Lainaus käyttäjältä: PP - toukokuu 01, 2012, 22:58:36 ip
Kätevä ja etenkin halpa systeemi, mutta et viittis pienentää noita kuvia. Hiukka leveitä ovat, kun selain koko ruudussa ei riitä full hd-näytöllä. :)


Kyllä täällä näkyy hyvin kuvat, tosin käytössä 27" iMac :)

chilley

Lainaus käyttäjältä: PP - toukokuu 02, 2012, 14:59:25 ip
Lainaus käyttäjältä: chilley - toukokuu 02, 2012, 00:10:10 ap
Saako tämän tehtyä suoraan foorumilta? Olen nimittäin linkannut nuo kuvat suoraan toiselta foorumilta. Voin toki pienentää kuvat ja uploadata ne uudestaan mikäli foorumilta ei moista toimintoa löydy.


Juu, laita img-kohtaan hakasulkujen sisään width=xxx, jossa xxx on kuvan leveys pikseleinä.


Tattista vaan! Joka päivä oppii jotain uutta. Näkyykös nyt paremmin? Laitoin leveydeksi 800px.
Jääkiekon maailmanmestaruuskisojen kunniaksi:
"Olen pelannut Gordie Howea ja Alexander Ragulinia vastaan, ja tiedän mitä kaukalossa oleminen tarkoittaa : "If you can't stand the heat, stay out of the kitchen". - Juhani "Tami" Tamminen

chilley

Myös tämän kaltainen viritelmä tuli vastaan. Tämä on kopioitu suoraan http://www.greenroofgrowers.blogspot.com blogista, samoin kuin myös tuo SIP.

Little Green Girl makes 2-liter SIPs (sub-irrigated planters) and you can apply the same concept to any watertight vessel, in this case an old wooden salad bowl. Check out how easy...

1) Make water+oxygen reservoir out of recycled drink bottle.  Use a basic soldering iron (best $12 you'll ever spend at Radio Shack) or hot nail to melt holes all over the bottle. Then melt a hole in one of the bottle's ends and insert a short piece of plastic drinking straw. This is the water overflow tube.



2) Make a fill tube by using a utility knife to cut an X in the bottle and inserting a piece of tubing like this...



...or cut another small drink bottle in half and insert as we've done below. This is where you'll add water. Note the same sub irrigation principle below, taking place in a recycled spinach box--more on this in a future post.



3) Put a hole in that bowl. We used a drill. You could also burn a hole. Make it big enough so the overflow straw/tube fits through it.





4) Thread the overflow tube through the hole and stand up the water+oxygen chamber. Like this:



5) Fill your vessel with damp potting mix. Use a peat/perlite combo to ensure good water wicking. Add some coir if you want. Mix in a handful of organic fertilizer, mounding up the mix and compressing lightly. Don't worry if a little mix falls into the holes of your bottle.



6) Plant something--seeds or young plant starts.
For seeds: get potting mix nice and moist, use a pencil to make quarter-inch-deep circles, and drop the seeds in about half an inch apart. Lightly cover with potting mix and gently press. Cover with a plastic bag to keep moisture in until seeds sprout. And then into the sun!

For lettuce or greens starts: Poke holes with a pencil and tuck plant roots deeply, lightly pressing into potting mix to make contact. One time only (so the plants can settle in), water plants and potting mix from the top. After that, water via the fill tube, like this:



Looks a little droopy,
but she'll settle in

Pour some water into the fill tube now to understand how the overflow spout works--see how extra water comes out of the straw? Tilt the bowl to offload some of that water. Once your plants get established and start drinking you can add more. Lettuces and greens love cool weather, so set them outside in the sun and don't bring inside unless there's danger of frost.

Mmm...we're already eating salads from this

Jääkiekon maailmanmestaruuskisojen kunniaksi:
"Olen pelannut Gordie Howea ja Alexander Ragulinia vastaan, ja tiedän mitä kaukalossa oleminen tarkoittaa : "If you can't stand the heat, stay out of the kitchen". - Juhani "Tami" Tamminen